The company XenteqWebsite Xenteq
The LBC 500 is a fully automatic battery charger and a maintenance charger in one and can be connected therefore be connected in continuous operation to the mains voltage and the battery. The microprocessor checks the battery and the loading procedure continuously providing a very safe and careful charging process. The internal electronics emerged from the latest developments, what came out is a particularly smart charger.
The LBC 500 can be used for a wide range of lead-acid batteries, including start, semi traction, full traction, GEL, AGM, calcium and spiral. The charger is suitable for many batteries, because the charging voltage is adjustable. See chapter "battery charger setting".
During the charging process, but also if the device is not in the battery loader phase, any devices can be switched on. The device then indirectly supplies the connected equipment with power. In this way the battery is relieved. Keep in mind, however, that the battery will charge slower. If you use the battery charger only (indirectly) as power source, switch the device to power supply, see chapter "battery charger setting", section 'Device as a source of power'.
It is no problem for the LBC when multiple power sources are connected at the same time, for example, a solar panel.
When open lead-acid batteries (semi traction/full traction, the heavily cyclical (diverse deep discharging)) are used, there is a possibility of an additional loading phase. Contact us for this.
The manufacturer indicates that there are several securities built in. According to the manufacturer the charger is protected against polarity reversal, short-circuit protection, temperature, temperature sensor control, input voltage, monitoring the input voltage, soft start, current-limiting, monitoring the charging time.
Delivery includes power cord and 12v connection cable with clamps and with eyelets.